Show your true colors with these customized Yankz! Tying your shoes is a thing of the past with this unique loop system and high-impact lightweight plastic cordlock. No more tying, retying, double knots or frazzled dirty laces to mess with. Just slip on your shoe and yankz. You're ready for action.
Directions
Step 1 :: With the Yankz! logo on the
buckle facing toward your ankle, lace the shoe from top to bottom (ankle to
toe).
Step 2 :: Thread cord ends
completely through holes at the wide end of the toe clip and back out through
the openings on the side.
Step 3 :: Pull upward on
cord loop (not plastic) above casing, and slide the casing down toward shoe
until it stops. Push T-Bar pin into casing to secure loop position. Stretch
cord loop downward and secure into "hook" of toe clip. Cord loop
should be snug as shown on packaging cover. Shoe slips on and off easily,
without having to unlock the system! Fit should be comfortable and secure, not
tight.
Step 4 :: If the fit is too
tight, or loop too short, pull some of the excess cord back through toe clip
and redistribute the slack by pulling cords up through eyelets towards the
ankle. If the fit is too loose or loop is too big, feed cord down from
ankle area through toe clip.
|
